2008 dodge nitro air blend door acuater.
2008 dodge nitro blend door actuator location.
The blend door hot cold actuator is on the drivers side and closest to the seat.
At least that is what i assume.
If heater core is getting coolant circulating through it then you may have a temp blend door or blend door actuator not working properly.
Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator.
If the actuator is tested off of the blend door it will simply turn.
Search fixya browse categories.
The other one on the drivers side is the mode door vent floor defrost it it higher up and very close to the firewall.
I don t have a nitro so can t tell you if this procedure is correct.
My husband changed the thermostat and also flushed the he.
Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing.
Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator.
2008 dodge nitro blend door.
Where is the heater blend door on a 2008 dodge nitro.
Both need to be diagnosed be a mechanic because they will required the dash to be removed to be repaired.
Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing.
Where is the heater blend door in a 2008 dodge nitro heater blows cold air dodge 2008 nitro question.
Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing.
The blend door is located in the air box under the dash and the actuator is located on the air box.
If both are hot then you might have a problem will the what they call a blend door actuator.
And the heater is not working.
The actuators are on the side of the hvac housing forward and between the seats under the radio.
The defrost works but then you turn it to the vents it only blows cool air.